Batch Post Error - Subcontracts

Review the following items if a Subcontract cannot be posted to Sage 100 Contractor.

1. Relink Sage Construction Management and Sage 100 Contractor Vendor as follows:
   1. Go to Accounting Link.
   2. Select the Contact Management tab.
   3. Select Manually Link Vendor under the Manually Link section.
   4. Find the Sage CM Vendor referenced on the Subcontract and link it to the Sage 100 Contractor Vendor.
2. Run the Batch Post Wizard and try posting the Subcontract again as follows:
   1. Select the Posting tab.
   2. Select Batch Post Wizard.
   3. Post the Subcontract.
3. If an error occurs, review the Posting Preferences as follows:
   1. Select Posting Preferences.
   2. Select the Resource Type and Cost Codes tab and review the following properties:
      • Cost Resource Type Mapping: All Sage Construction Management resources (M, L, E, S, O) must be linked to a Sage 100 Contractor resource, especially S for Subcontracts.
      • Cost Code Mapping Logic and Default Cost Code or when no match.
        Review how the job cost codes referenced on the Sage Construction Management Subcontract correlate to Sage 100 Contractor Cost Codes based on the Cost Code Logic property.
   3. Save your changes, if any.
   4. Run the Batch Post Wizard again to post the Subcontract.